氫氧化鉀現在被廣泛的進行使用，在產品的制造方法中，有一種叫做隔膜電解的方法。那么隔膜法氫氧化鉀濃度是多少？該方法的制造步驟和該方法制造出來的成品又可以應用于哪些方面？以下就由小編來為大家詳細的解釋一下吧:

Potassium hydroxide is now widely used. Among the manufacturing methods of products, there is a method called diaphragm electrolysis. What is the concentration of potassium hydroxide in diaphragm method? What are the manufacturing steps of the method and the finished products produced by the method? The following is a detailed explanation by the editor:

隔膜法所得氫氧化鉀濃度為10%～11%，需通過蒸發濃縮和冷卻澄清，制得含45%～50%氫氧化鉀溶液;也可繼續在熬堿鍋中濃縮，經脫色，制得固體氫氧化鉀，或經制片成片狀氫氧化鉀產品。

The concentration of potassium hydroxide obtained by diaphragm method is 10%~11%, which needs to be concentrated by evaporation and clarified by cooling to prepare potassium hydroxide solution containing 45%~50%; It can also be concentrated in the alkali boiling pot and decolorized to obtain solid potassium hydroxide or flaked potassium hydroxide products.

隔膜電解法的原料氯化鉀在化鹽槽中溶解成飽和溶液。當加熱到90℃的時候，單獨加入碳酸鉀，苛性鉀，氯化鋇除鈣，鎂和硫酸鹽等雜質。經過沉淀然后去渣。用鹽酸中和。將280~315g/l氯化鉀溶液預熱70~75℃,然后電解得到氫氧化鉀。

The raw potassium chloride of diaphragm electrolysis is dissolved into a saturated solution in the salt dissolving tank. When heated to 90 ℃, potassium carbonate, caustic potash and barium chloride are added separately to remove impurities such as calcium, magnesium and sulfate. After sedimentation, the slag is removed. Neutralize with hydrochloric acid. Preheat 280~315 g/l potassium chloride solution to 70~75 ℃, and then electrolyze to obtain potassium hydroxide.

含量分析：

Content analysis:

精確稱取試樣約1.5g，溶于40mL新煮沸并冷卻后的水中，冷15℃，加酚酞試液（TS-167）數滴，用1mol/L硫酸滴定。在粉紅色消失時，記錄所耗的酸量，加甲基橙試液（TS-148）數滴，繼續滴定呈現持續不褪的粉紅色。記錄滴定所需酸的總體積。每1mol/L硫酸相當于總堿量（以KOH計）56.11mg。

Accurately weigh about 1.5g of the sample, dissolve it in 40mL of newly boiled and cooled water, cool it to 15 ℃, add several drops of phenolphthalein test solution (TS-167), and titrate it with 1mol/L sulfuric acid. When the pink color disappears, record the amount of acid consumed, add a few drops of methyl orange test solution (TS-148), and continue titrating until a persistent pink color appears. Record the total volume of acid required for titration. Each 1mol/L of sulfuric acid is equivalent to 56.11mg of total alkali (calculated by KOH).

氫氧化鉀隔膜法得到的產品濃度是百分之十到百分之十一，需要蒸發濃縮且冷卻澄清。配制含百分之四十五到五十的產品溶液；也可以在堿煮鍋中濃縮。經過脫色制備固體產品或者是壓片成片狀的產品。

The concentration of the product obtained by the potassium hydroxide diaphragm method is 10% to 11%, which requires evaporation, concentration and cooling for clarification. Prepare a product solution containing 45 to 50 percent; It can also be concentrated in an alkali boiler. After decolorization, solid products are prepared or pressed into sheets.

在今后的操作和使用的時候我們每個人都應該更加重視這方面的知識，更多地的去了解產品的制造方法，這樣對我們區分產品的應用領域也是有利的且還有利于每個人的產品使用。更多產品相關內容就來我們網站http://m.yiqijieneng.cn進行咨詢了解吧！

In the future operation and use, each of us should pay more attention to this knowledge and learn more about the manufacturing methods of products, which is also beneficial for us to distinguish the application fields of products and is also conducive to everyone's product use. More product related content will come to our website http://m.yiqijieneng.cn Consult and understand!